uboot/u-boot-stm32mp-2020.01/board/grinn/liteboard
chenyf 996bded6bb 1 2024-01-10 14:52:34 +08:00
..
Kconfig 1 2024-01-10 14:52:34 +08:00
MAINTAINERS 1 2024-01-10 14:52:34 +08:00
Makefile 1 2024-01-10 14:52:34 +08:00
README 1 2024-01-10 14:52:34 +08:00
board.c 1 2024-01-10 14:52:34 +08:00

README

How to use U-Boot on Grinn's liteBoard
--------------------------------------

- Build U-Boot for liteBoard:

$ make mrproper
$ make liteboard_defconfig
$ make

This will generate the SPL image called SPL and the u-boot.img.

- Flash the SPL image into the micro SD card:

sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync

- Flash the u-boot.img image into the micro SD card:

sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync

- Jumper settings:

S1: 0 1 0 1 1 1

where 0 means bottom position and 1 means top position (from the
switch label numbers reference).

- Insert the micro SD card in the board.

- Connect USB cable between liteBoard and the PC for the power and console.

- U-Boot messages should come up.