151 lines
3.7 KiB
C
151 lines
3.7 KiB
C
// SPDX-License-Identifier: GPL-2.0+
|
|
/*
|
|
* (C) Copyright 2016 Beniamino Galvani <b.galvani@gmail.com>
|
|
* (C) Copyright 2018 Neil Armstrong <narmstrong@baylibre.com>
|
|
*/
|
|
|
|
#include <common.h>
|
|
#include <asm/arch/boot.h>
|
|
#include <asm/arch/eth.h>
|
|
#include <asm/arch/gx.h>
|
|
#include <asm/arch/mem.h>
|
|
#include <asm/arch/meson-vpu.h>
|
|
#include <asm/io.h>
|
|
#include <asm/armv8/mmu.h>
|
|
#include <linux/sizes.h>
|
|
#include <phy.h>
|
|
|
|
DECLARE_GLOBAL_DATA_PTR;
|
|
|
|
int meson_get_boot_device(void)
|
|
{
|
|
return readl(GX_AO_SEC_GP_CFG0) & GX_AO_BOOT_DEVICE;
|
|
}
|
|
|
|
/* Configure the reserved memory zones exported by the secure registers
|
|
* into EFI and DTB reserved memory entries.
|
|
*/
|
|
void meson_init_reserved_memory(void *fdt)
|
|
{
|
|
u64 bl31_size, bl31_start;
|
|
u64 bl32_size, bl32_start;
|
|
u32 reg;
|
|
|
|
/*
|
|
* Get ARM Trusted Firmware reserved memory zones in :
|
|
* - AO_SEC_GP_CFG3: bl32 & bl31 size in KiB, can be 0
|
|
* - AO_SEC_GP_CFG5: bl31 physical start address, can be NULL
|
|
* - AO_SEC_GP_CFG4: bl32 physical start address, can be NULL
|
|
*/
|
|
reg = readl(GX_AO_SEC_GP_CFG3);
|
|
|
|
bl31_size = ((reg & GX_AO_BL31_RSVMEM_SIZE_MASK)
|
|
>> GX_AO_BL31_RSVMEM_SIZE_SHIFT) * SZ_1K;
|
|
bl32_size = (reg & GX_AO_BL32_RSVMEM_SIZE_MASK) * SZ_1K;
|
|
|
|
bl31_start = readl(GX_AO_SEC_GP_CFG5);
|
|
bl32_start = readl(GX_AO_SEC_GP_CFG4);
|
|
|
|
/*
|
|
* Early Meson GX Firmware revisions did not provide the reserved
|
|
* memory zones in the registers, keep fixed memory zone handling.
|
|
*/
|
|
if (IS_ENABLED(CONFIG_MESON_GX) &&
|
|
!reg && !bl31_start && !bl32_start) {
|
|
bl31_start = 0x10000000;
|
|
bl31_size = 0x200000;
|
|
}
|
|
|
|
/* Add first 16MiB reserved zone */
|
|
meson_board_add_reserved_memory(fdt, 0, GX_FIRMWARE_MEM_SIZE);
|
|
|
|
/* Add BL31 reserved zone */
|
|
if (bl31_start && bl31_size)
|
|
meson_board_add_reserved_memory(fdt, bl31_start, bl31_size);
|
|
|
|
/* Add BL32 reserved zone */
|
|
if (bl32_start && bl32_size)
|
|
meson_board_add_reserved_memory(fdt, bl32_start, bl32_size);
|
|
|
|
#if defined(CONFIG_VIDEO_MESON)
|
|
meson_vpu_rsv_fb(fdt);
|
|
#endif
|
|
}
|
|
|
|
phys_size_t get_effective_memsize(void)
|
|
{
|
|
/* Size is reported in MiB, convert it in bytes */
|
|
return ((readl(GX_AO_SEC_GP_CFG0) & GX_AO_MEM_SIZE_MASK)
|
|
>> GX_AO_MEM_SIZE_SHIFT) * SZ_1M;
|
|
}
|
|
|
|
static struct mm_region gx_mem_map[] = {
|
|
{
|
|
.virt = 0x0UL,
|
|
.phys = 0x0UL,
|
|
.size = 0xc0000000UL,
|
|
.attrs = PTE_BLOCK_MEMTYPE(MT_NORMAL) |
|
|
PTE_BLOCK_INNER_SHARE
|
|
}, {
|
|
.virt = 0xc0000000UL,
|
|
.phys = 0xc0000000UL,
|
|
.size = 0x30000000UL,
|
|
.attrs = PTE_BLOCK_MEMTYPE(MT_DEVICE_NGNRNE) |
|
|
PTE_BLOCK_NON_SHARE |
|
|
PTE_BLOCK_PXN | PTE_BLOCK_UXN
|
|
}, {
|
|
/* List terminator */
|
|
0,
|
|
}
|
|
};
|
|
|
|
struct mm_region *mem_map = gx_mem_map;
|
|
|
|
/* Configure the Ethernet MAC with the requested interface mode
|
|
* with some optional flags.
|
|
*/
|
|
void meson_eth_init(phy_interface_t mode, unsigned int flags)
|
|
{
|
|
switch (mode) {
|
|
case PHY_INTERFACE_MODE_RGMII:
|
|
case PHY_INTERFACE_MODE_RGMII_ID:
|
|
case PHY_INTERFACE_MODE_RGMII_RXID:
|
|
case PHY_INTERFACE_MODE_RGMII_TXID:
|
|
/* Set RGMII mode */
|
|
setbits_le32(GX_ETH_REG_0, GX_ETH_REG_0_PHY_INTF |
|
|
GX_ETH_REG_0_TX_PHASE(1) |
|
|
GX_ETH_REG_0_TX_RATIO(4) |
|
|
GX_ETH_REG_0_PHY_CLK_EN |
|
|
GX_ETH_REG_0_CLK_EN);
|
|
|
|
/* Reset to external PHY */
|
|
if(!IS_ENABLED(CONFIG_MESON_GXBB))
|
|
writel(0x2009087f, GX_ETH_REG_3);
|
|
|
|
break;
|
|
|
|
case PHY_INTERFACE_MODE_RMII:
|
|
/* Set RMII mode */
|
|
out_le32(GX_ETH_REG_0, GX_ETH_REG_0_INVERT_RMII_CLK |
|
|
GX_ETH_REG_0_CLK_EN);
|
|
|
|
/* Use GXL RMII Internal PHY (also on GXM) */
|
|
if (!IS_ENABLED(CONFIG_MESON_GXBB)) {
|
|
if ((flags & MESON_USE_INTERNAL_RMII_PHY)) {
|
|
writel(0x10110181, GX_ETH_REG_2);
|
|
writel(0xe40908ff, GX_ETH_REG_3);
|
|
} else
|
|
writel(0x2009087f, GX_ETH_REG_3);
|
|
}
|
|
|
|
break;
|
|
|
|
default:
|
|
printf("Invalid Ethernet interface mode\n");
|
|
return;
|
|
}
|
|
|
|
/* Enable power gate */
|
|
clrbits_le32(GX_MEM_PD_REG_0, GX_MEM_PD_REG_0_ETH_MASK);
|
|
}
|