Next: , Previous: Typedefs, Up: Types


5.10 Unions

     union u_tag {
       int  u_int;
       float u_float;
       char* u_char;
     } an_u;

This code generates a stab for a union tag and a stab for a union variable. Both use the N_LSYM stab type. If a union variable is scoped locally to the procedure in which it is defined, its stab is located immediately preceding the N_LBRAC for the procedure's block start.

The stab for the union tag, however, is located preceding the code for the procedure in which it is defined. The stab type is N_LSYM. This would seem to imply that the union type is file scope, like the struct type s_tag. This is not true. The contents and position of the stab for u_type do not convey any information about its procedure local scope.

     # 128 is N_LSYM
     .stabs "u_tag:T23=u4u_int:1,0,32;u_float:12,0,32;u_char:21,0,32;;",
            128,0,0,0

The symbol descriptor ‘T’, following the ‘name:’ means that the stab describes an enumeration, structure, or union tag. The type descriptor ‘u’, following the ‘23=’ of the type definition, narrows it down to a union type definition. Following the ‘u’ is the number of bytes in the union. After that is a list of union element descriptions. Their format is ‘name:type, bit offset into the union, number of bytes for the element;’.

The stab for the union variable is:

     .stabs "an_u:23",128,0,0,-20     # 128 is N_LSYM

-20’ specifies where the variable is stored (see Stack Variables).