30 lines
1.1 KiB
Plaintext
30 lines
1.1 KiB
Plaintext
Analog Devices LT3651 Charger Power Supply bindings: lt3651-charger
|
|
|
|
Required properties:
|
|
- compatible: Should contain one of the following:
|
|
* "lltc,ltc3651-charger", (DEPRECATED: Use "lltc,lt3651-charger")
|
|
* "lltc,lt3651-charger"
|
|
- lltc,acpr-gpios: Connect to ACPR output. See remark below.
|
|
|
|
Optional properties:
|
|
- lltc,fault-gpios: Connect to FAULT output. See remark below.
|
|
- lltc,chrg-gpios: Connect to CHRG output. See remark below.
|
|
|
|
The lt3651 outputs are open-drain type and active low. The driver assumes the
|
|
GPIO reports "active" when the output is asserted, so if the pins have been
|
|
connected directly, the GPIO flags should be set to active low also.
|
|
|
|
The driver will attempt to aquire interrupts for all GPIOs to detect changes in
|
|
line state. If the system is not capabale of providing interrupts, the driver
|
|
cannot report changes and userspace will need to periodically read the sysfs
|
|
attributes to detect changes.
|
|
|
|
Example:
|
|
|
|
charger: battery-charger {
|
|
compatible = "lltc,lt3651-charger";
|
|
lltc,acpr-gpios = <&gpio0 68 GPIO_ACTIVE_LOW>;
|
|
lltc,fault-gpios = <&gpio0 64 GPIO_ACTIVE_LOW>;
|
|
lltc,chrg-gpios = <&gpio0 63 GPIO_ACTIVE_LOW>;
|
|
};
|