33 lines
1.0 KiB
Plaintext
33 lines
1.0 KiB
Plaintext
|
* Spreadtrum serial UART
|
||
|
|
|
||
|
|
Required properties:
|
||
|
|
- compatible: must be one of:
|
||
|
|
* "sprd,sc9836-uart"
|
||
|
|
* "sprd,sc9860-uart", "sprd,sc9836-uart"
|
||
|
|
|
||
|
|
- reg: offset and length of the register set for the device
|
||
|
|
- interrupts: exactly one interrupt specifier
|
||
|
|
- clock-names: Should contain following entries:
|
||
|
|
"enable" for UART module enable clock,
|
||
|
|
"uart" for UART clock,
|
||
|
|
"source" for UART source (parent) clock.
|
||
|
|
- clocks: Should contain a clock specifier for each entry in clock-names.
|
||
|
|
UART clock and source clock are optional properties, but enable clock
|
||
|
|
is required.
|
||
|
|
|
||
|
|
Optional properties:
|
||
|
|
- dma-names: Should contain "rx" for receive and "tx" for transmit channels.
|
||
|
|
- dmas: A list of dma specifiers, one for each entry in dma-names.
|
||
|
|
|
||
|
|
Example:
|
||
|
|
uart0: serial@0 {
|
||
|
|
compatible = "sprd,sc9860-uart",
|
||
|
|
"sprd,sc9836-uart";
|
||
|
|
reg = <0x0 0x100>;
|
||
|
|
interrupts = <GIC_SPI 2 IRQ_TYPE_LEVEL_HIGH>;
|
||
|
|
dma-names = "rx", "tx";
|
||
|
|
dmas = <&ap_dma 19>, <&ap_dma 20>;
|
||
|
|
clock-names = "enable", "uart", "source";
|
||
|
|
clocks = <&clk_ap_apb_gates 9>, <&clk_uart0>, <&ext_26m>;
|
||
|
|
};
|