28 lines
998 B
Plaintext
28 lines
998 B
Plaintext
|
* PTN5150 CC (Configuration Channel) Logic device
|
||
|
|
|
||
|
|
PTN5150 is a small thin low power CC logic chip supporting the USB Type-C
|
||
|
|
connector application with CC control logic detection and indication functions.
|
||
|
|
It is interfaced to the host controller using an I2C interface.
|
||
|
|
|
||
|
|
Required properties:
|
||
|
|
- compatible: should be "nxp,ptn5150"
|
||
|
|
- reg: specifies the I2C slave address of the device
|
||
|
|
- int-gpio: should contain a phandle and GPIO specifier for the GPIO pin
|
||
|
|
connected to the PTN5150's INTB pin.
|
||
|
|
- vbus-gpio: should contain a phandle and GPIO specifier for the GPIO pin which
|
||
|
|
is used to control VBUS.
|
||
|
|
- pinctrl-names : a pinctrl state named "default" must be defined.
|
||
|
|
- pinctrl-0 : phandle referencing pin configuration of interrupt and vbus
|
||
|
|
control.
|
||
|
|
|
||
|
|
Example:
|
||
|
|
ptn5150@1d {
|
||
|
|
compatible = "nxp,ptn5150";
|
||
|
|
reg = <0x1d>;
|
||
|
|
int-gpio = <&msmgpio 78 GPIO_ACTIVE_HIGH>;
|
||
|
|
vbus-gpio = <&msmgpio 148 GPIO_ACTIVE_HIGH>;
|
||
|
|
pinctrl-names = "default";
|
||
|
|
pinctrl-0 = <&ptn5150_default>;
|
||
|
|
status = "okay";
|
||
|
|
};
|