110 lines
2.9 KiB
C
110 lines
2.9 KiB
C
|
// SPDX-License-Identifier: GPL-2.0-only
|
||
|
|
/*
|
||
|
|
* linux/arch/arm/plat-versatile/platsmp.c
|
||
|
|
*
|
||
|
|
* Copyright (C) 2002 ARM Ltd.
|
||
|
|
* All Rights Reserved
|
||
|
|
*
|
||
|
|
* This code is specific to the hardware found on ARM Realview and
|
||
|
|
* Versatile Express platforms where the CPUs are unable to be individually
|
||
|
|
* woken, and where there is no way to hot-unplug CPUs. Real platforms
|
||
|
|
* should not copy this code.
|
||
|
|
*/
|
||
|
|
#include <linux/init.h>
|
||
|
|
#include <linux/errno.h>
|
||
|
|
#include <linux/delay.h>
|
||
|
|
#include <linux/device.h>
|
||
|
|
#include <linux/jiffies.h>
|
||
|
|
#include <linux/smp.h>
|
||
|
|
|
||
|
|
#include <asm/cacheflush.h>
|
||
|
|
#include <asm/smp_plat.h>
|
||
|
|
|
||
|
|
#include <plat/platsmp.h>
|
||
|
|
|
||
|
|
/*
|
||
|
|
* versatile_cpu_release controls the release of CPUs from the holding
|
||
|
|
* pen in headsmp.S, which exists because we are not always able to
|
||
|
|
* control the release of individual CPUs from the board firmware.
|
||
|
|
* Production platforms do not need this.
|
||
|
|
*/
|
||
|
|
volatile int versatile_cpu_release = -1;
|
||
|
|
|
||
|
|
/*
|
||
|
|
* Write versatile_cpu_release in a way that is guaranteed to be visible to
|
||
|
|
* all observers, irrespective of whether they're taking part in coherency
|
||
|
|
* or not. This is necessary for the hotplug code to work reliably.
|
||
|
|
*/
|
||
|
|
static void versatile_write_cpu_release(int val)
|
||
|
|
{
|
||
|
|
versatile_cpu_release = val;
|
||
|
|
smp_wmb();
|
||
|
|
sync_cache_w(&versatile_cpu_release);
|
||
|
|
}
|
||
|
|
|
||
|
|
/*
|
||
|
|
* versatile_lock exists to avoid running the loops_per_jiffy delay loop
|
||
|
|
* calibrations on the secondary CPU while the requesting CPU is using
|
||
|
|
* the limited-bandwidth bus - which affects the calibration value.
|
||
|
|
* Production platforms do not need this.
|
||
|
|
*/
|
||
|
|
static DEFINE_RAW_SPINLOCK(versatile_lock);
|
||
|
|
|
||
|
|
void versatile_secondary_init(unsigned int cpu)
|
||
|
|
{
|
||
|
|
/*
|
||
|
|
* let the primary processor know we're out of the
|
||
|
|
* pen, then head off into the C entry point
|
||
|
|
*/
|
||
|
|
versatile_write_cpu_release(-1);
|
||
|
|
|
||
|
|
/*
|
||
|
|
* Synchronise with the boot thread.
|
||
|
|
*/
|
||
|
|
raw_spin_lock(&versatile_lock);
|
||
|
|
raw_spin_unlock(&versatile_lock);
|
||
|
|
}
|
||
|
|
|
||
|
|
int versatile_boot_secondary(unsigned int cpu, struct task_struct *idle)
|
||
|
|
{
|
||
|
|
unsigned long timeout;
|
||
|
|
|
||
|
|
/*
|
||
|
|
* Set synchronisation state between this boot processor
|
||
|
|
* and the secondary one
|
||
|
|
*/
|
||
|
|
raw_spin_lock(&versatile_lock);
|
||
|
|
|
||
|
|
/*
|
||
|
|
* This is really belt and braces; we hold unintended secondary
|
||
|
|
* CPUs in the holding pen until we're ready for them. However,
|
||
|
|
* since we haven't sent them a soft interrupt, they shouldn't
|
||
|
|
* be there.
|
||
|
|
*/
|
||
|
|
versatile_write_cpu_release(cpu_logical_map(cpu));
|
||
|
|
|
||
|
|
/*
|
||
|
|
* Send the secondary CPU a soft interrupt, thereby causing
|
||
|
|
* the boot monitor to read the system wide flags register,
|
||
|
|
* and branch to the address found there.
|
||
|
|
*/
|
||
|
|
arch_send_wakeup_ipi_mask(cpumask_of(cpu));
|
||
|
|
|
||
|
|
timeout = jiffies + (1 * HZ);
|
||
|
|
while (time_before(jiffies, timeout)) {
|
||
|
|
smp_rmb();
|
||
|
|
if (versatile_cpu_release == -1)
|
||
|
|
break;
|
||
|
|
|
||
|
|
udelay(10);
|
||
|
|
}
|
||
|
|
|
||
|
|
/*
|
||
|
|
* now the secondary core is starting up let it run its
|
||
|
|
* calibrations, then wait for it to finish
|
||
|
|
*/
|
||
|
|
raw_spin_unlock(&versatile_lock);
|
||
|
|
|
||
|
|
return versatile_cpu_release != -1 ? -ENOSYS : 0;
|
||
|
|
}
|