11 nlmconv

nlmconv converts a relocatable object file into a NetWare Loadable Module.

Warning: nlmconv is not always built as part of the binary utilities, since it is only useful for NLM targets.

nlmconv [-I bfdname|--input-target=bfdname]
        [-O bfdname|--output-target=bfdname]
        [-T headerfile|--header-file=headerfile]
        [-d|--debug] [-l linker|--linker=linker]
        [-h|--help] [-V|--version]
        infile outfile

nlmconv converts the relocatable ‘i386’ object file infile into the NetWare Loadable Module outfile, optionally reading headerfile for NLM header information. For instructions on writing the NLM command file language used in header files, see the ‘linkers’ section, ‘NLMLINK’ in particular, of the NLM Development and Tools Overview, which is part of the NLM Software Developer’s Kit (“NLM SDK”), available from Novell, Inc. nlmconv uses the GNU Binary File Descriptor library to read infile; see BFD in Using LD, for more information.

nlmconv can perform a link step. In other words, you can list more than one object file for input if you list them in the definitions file (rather than simply specifying one input file on the command line). In this case, nlmconv calls the linker for you.

-I bfdname

--input-target=bfdname

Object format of the input file. nlmconv can usually determine the format of a given file (so no default is necessary). See Target Selection, for more information.

-O bfdname

--output-target=bfdname

Object format of the output file. nlmconv infers the output format based on the input format, e.g. for a ‘i386’ input file the output format is ‘nlm32-i386’. See Target Selection, for more information.

-T headerfile

--header-file=headerfile

Reads headerfile for NLM header information. For instructions on writing the NLM command file language used in header files, see see the ‘linkers’ section, of the NLM Development and Tools Overview, which is part of the NLM Software Developer’s Kit, available from Novell, Inc.

-d

--debug

Displays (on standard error) the linker command line used by nlmconv.

-l linker

--linker=linker

Use linker for any linking. linker can be an absolute or a relative pathname.

-h

--help

Prints a usage summary.

-V

--version

Prints the version number for nlmconv.