56 lines
1.6 KiB
Plaintext
56 lines
1.6 KiB
Plaintext
Pistachio Reset Controller
|
|
=============================================================================
|
|
|
|
This binding describes a reset controller device that is used to enable and
|
|
disable individual IP blocks within the Pistachio SoC using "soft reset"
|
|
control bits found in the Pistachio SoC top level registers.
|
|
|
|
The actual action taken when soft reset is asserted is hardware dependent.
|
|
However, when asserted it may not be possible to access the hardware's
|
|
registers, and following an assert/deassert sequence the hardware's previous
|
|
state may no longer be valid.
|
|
|
|
Please refer to Documentation/devicetree/bindings/reset/reset.txt
|
|
for common reset controller binding usage.
|
|
|
|
Required properties:
|
|
|
|
- compatible: Contains "img,pistachio-reset"
|
|
|
|
- #reset-cells: Contains 1
|
|
|
|
Example:
|
|
|
|
cr_periph: clk@18148000 {
|
|
compatible = "img,pistachio-cr-periph", "syscon", "simple-mfd";
|
|
reg = <0x18148000 0x1000>;
|
|
clocks = <&clk_periph PERIPH_CLK_SYS>;
|
|
clock-names = "sys";
|
|
#clock-cells = <1>;
|
|
|
|
pistachio_reset: reset-controller {
|
|
compatible = "img,pistachio-reset";
|
|
#reset-cells = <1>;
|
|
};
|
|
};
|
|
|
|
Specifying reset control of devices
|
|
=======================================
|
|
|
|
Device nodes should specify the reset channel required in their "resets"
|
|
property, containing a phandle to the pistachio reset device node and an
|
|
index specifying which reset to use, as described in
|
|
Documentation/devicetree/bindings/reset/reset.txt.
|
|
|
|
Example:
|
|
|
|
spdif_out: spdif-out@18100d00 {
|
|
...
|
|
resets = <&pistachio_reset PISTACHIO_RESET_SPDIF_OUT>;
|
|
reset-names = "rst";
|
|
...
|
|
};
|
|
|
|
Macro definitions for the supported resets can be found in:
|
|
include/dt-bindings/reset/pistachio-resets.h
|