33 lines
1.0 KiB
Plaintext
33 lines
1.0 KiB
Plaintext
|
* HDMI CEC GPIO driver
|
||
|
|
|
||
|
|
The HDMI CEC GPIO module supports CEC implementations where the CEC line
|
||
|
|
is hooked up to a pull-up GPIO line and - optionally - the HPD line is
|
||
|
|
hooked up to another GPIO line.
|
||
|
|
|
||
|
|
Required properties:
|
||
|
|
- compatible: value must be "cec-gpio".
|
||
|
|
- cec-gpios: gpio that the CEC line is connected to. The line should be
|
||
|
|
tagged as open drain.
|
||
|
|
|
||
|
|
If the CEC line is associated with an HDMI receiver/transmitter, then the
|
||
|
|
following property is also required:
|
||
|
|
|
||
|
|
- hdmi-phandle - phandle to the HDMI controller, see also cec.txt.
|
||
|
|
|
||
|
|
If the CEC line is not associated with an HDMI receiver/transmitter, then
|
||
|
|
the following property is optional:
|
||
|
|
|
||
|
|
- hpd-gpios: gpio that the HPD line is connected to.
|
||
|
|
|
||
|
|
Example for the Raspberry Pi 3 where the CEC line is connected to
|
||
|
|
pin 26 aka BCM7 aka CE1 on the GPIO pin header and the HPD line is
|
||
|
|
connected to pin 11 aka BCM17:
|
||
|
|
|
||
|
|
#include <dt-bindings/gpio/gpio.h>
|
||
|
|
|
||
|
|
cec-gpio {
|
||
|
|
compatible = "cec-gpio";
|
||
|
|
cec-gpios = <&gpio 7 (GPIO_ACTIVE_HIGH|GPIO_OPEN_DRAIN)>;
|
||
|
|
hpd-gpios = <&gpio 17 GPIO_ACTIVE_HIGH>;
|
||
|
|
};
|